Suyitno, Eko Pujiyulianto, B. Arifvianto
The research aims to observe the effect of EDM pulse current and the easiness of the EDM process in the hole making for strut cardiac stent CP-Ti-2 in comparison to the hole making for the strut cardiac stent AISI 316 L. The process was conducted using die-sinking EDM. It was carried out at different pulse currents (1.5 - 6.0 A). The surface roughness was evaluated, and the diameter of the crater was measured. The easiness of EDM was defined based on the pulse current, the length of the cardiac stent, the percent of tool wear, the λ Ө and λ Ө ρ theories. The result shows that the surface roughness, the crater diameter, the crater valley, and the MRR increase with pulse current. The cardiac stents CP-Ti-2 use a higher pulse current (3.0 A) compared to AISI 316 L (1.5 A). The manufacturing time for cardiac stent CP-Ti-2 is longer, and the product is shorter in length compared to AISI 316L. The percent of tool wear used in the manufacturing of cardiac stent CP-Ti-2 and AISI 316 L is 68.75 and 19.75 percent, respectively. The experimental results correlate to the λ Ө theory. © 2024 Informa UK Limited, trading as Taylor & Francis Group.
Mechanical Engineering, Faculty of Engineering, Universitas Tidar (UNTID), North Magelang, Central Java, Indonesia; Center for Innovation of Medical Equipment and Devices (CIMEDs), Universitas Gadjah Mada, Yogyakarta, Indonesia; Mechanical Engineering, Institut Teknologi Sumatera (ITERA), South Lampung, Lampung, Indonesia; Department of Mechanical and Industrial Engineering Department, Engineering Faculty, Universitas Gadjah Mada (UGM), Yogyakarta, Indonesia
Research at a Glance
Register to unlock
Topics & SDG Alignment
Register to unlock
Collaboration
Register to unlock
Author Profile (Selected)
Register to unlock
References Overview
Register to unlock
Journal & Source
Register to unlock
Metadata & Integrity
Register to unlock